Questions? Call Us Today! (513) 575-4200

How to Measure For A Custom Driveshaft

find your specific measurement below

Driveshaft Measurement

We care for our work

Measure from the edge of the seal
(Not the output shaft)
to the centerline of the rear u-joint.

**Measure at ride height.
The car can be lifted under the differential but make sure it has the weight on the rear springs**

To properly measure the rear end yoke, first determine if the yoke has (2) tabs that the rear joint will sit-in between or if there is not tabs (tabs are in the picture above) or if it has a flat plate.

The size changes in increments of 1/16(1-1/16|1-1/8|1-3/26)

Please Provide the Following Information:

1. Transmission Year/Make/Model (please advise spline count if possible)

2. Differential Info: What did it come from (did it have u-bolts or straps and (4) bolts or it was a flat plate)

3. What HP and torque does the engine currrently produce?

4. If the car is being built for competition, please give us a full run down of the car, weight , tire size and rear ratio all of this will help get you the correct shaft.

Download the measurements below:

1.  CAR or 2 Wheel Drive truck applications

2. Measuring the rear u-joint

3. Most FORD vehicles – Option 1 , Option 2

4.  For 4X4 vehicles – Option 1

5.  Most 4X4 Front shafts

6.  Most 4×4 Rear shafts – Option 1 , Option 2

Add comment